Input Type: (Rtd) - Omega DP41-B User Manual

12.2 INPUT TYPE: ( RTD )
Press 'MENU'
Press 'RESET/ENTER'
Press ' /MAX'
Rtd
Press ' /MAX'
Press 'RESET/ENTER'
Press 'RESET/ENTER'
Press ' /MAX'
Press 'RESET/ENTER'
Display
2Pt 392
3Pt 392
4Pt 392
2Pt 385
3Pt 385
4Pt 385
3.L INR
4.L INR
ENTER INPUT TYPE MENU:
1) Display shows "INPUt" Input Menu.
2) Display flashes "VOLt" (default) or previous stored input type.
3) Scroll through the available following input type selection list. Display
flashes:
"VOLt" (DC Voltage)
"CURRNt" (DC Current)
"bRIdGE" (Bridge)
"POt" (Potentiometer)
"tC" (Thermocouple)
"Rtd" (RTD)
If the displayed input type is "Rtd", press 'RESET/ENTER' to skip to Step 6
("Rtd" stops flashing).
"Rtd" RTD SUBMENU:
4) Scroll through the available selection to "Rtd" (flashing).
5) Display shows "StOREd" stored message momentarily and then "Rtd"
(not flashing).
6) Display flashes previous RTD type selection. ie. "4Pt 385" default
(see Table below for types). If the display matches your choice of RTD
type. Go to Step 8
7) Scroll through the available RTD types to the selection of our choice.
8) Display shows "StOREd" stored message momentarily and then
advances to the "RdG.CNF" Reading Configuration Menu.
RTD types
2 wire, 100 Ohms, NIST RTD, alpha=0.00392
3 wire, 100 Ohms, NIST RTD, alpha=0.00392
4 wire, 100 Ohms, NIST RTD, alpha=0.00392
2 wire, 100 Ohms, NIST RTD, alpha=0.00385
3 wire, 100 Ohms, NIST RTD, alpha=0.00385
4 wire, 100 Ohms, NIST RTD, alpha=0.00385
3 wire, linear RTD
4 wire, linear RTD
Input Type Selection
12
45