Omega DP41-B User Manual page 18

4
Parts of the Meter
BUTTON
SETPTS
/MAX
/MIN
8
Function in Configuration Mode
• This button functions only in Run Mode. When the
Setpoint/Alarm features are unlocked, pressing this
button sequentially recalls the previous setpoint settings
to the display. After the ' /MIN' and ' /MAX' buttons
are used to alter those values, as desired, pressing the
'SETPTS' button again, stores these new values.
• At any step within this Setpoint Settings Mode, each of
the four setpoint values are displayed for approximately
10 seconds after the last press of any of the 'SETPTS',
' /MIN' and ' /MAX' buttons.
• Press the up ' /MAX' button to scroll through "flashing"
selections. If the function requires a numerical value to
be entered and displayed, press this key to increase
value of a parameter that is currently being modified.
The " - " Minus sign will be available at the first digit
from left side of display.
• In the Run Mode, pressing the ' /MAX' button causes
the display to flash the PEAK "HI RdG" Reading value
– press again to return to the Run Mode.
• Press the ' /MIN' button to go back to a previous
Level Menu item, or Run Mode if the last menu was one
of Main Menu items.
• Press this button twice to back up further to the Main
Menu item (Main Menu) or Run Mode, if the last menu
was the submenu of the Main Menu item, in Menu
Configuration Mode.
• Press this button three times in Menu Configuration Mode
as necessary to reset the controller to the Run Mode.
• When a numerical value is flashing, press this button to
step through digits from left to right, allowing the user to
select the desired digit to modify. If all digits are not
flashing and decimal point is, press ' /MAX' to select
decimal point position to display it (or even without decimal
point appearance due to the nature of LED display in the
last operation).
• In the Run Mode pressing the ' /MIN' causes the
display to flash the VALLEY "LO RdG" reading value
– press again to return to the Run Mode.