Omega DP41-B User Manual page 73

ON.L INE
Press 'RESET/ENTER'
Press ' /MAX'
Press 'RESET/ENTER'
Press 'RESET/ENTER'
Press 'RESET/ENTER'
Press 'RESET/ENTER'
Press 'RESET/ENTER'
Press ' /MAX' & '
Press 'RESET/ENTER'
Press 'RESET/ENTER'
MANUAL
Press 'RESET/ENTER'
Press 'RESET/ENTER'
Press 'RESET/ENTER'
Press ' /MAX' & '
Press 'RESET/ENTER'
Press 'RESET/ENTER'
Input Configuration Menu
30) Display flashes "ON.L INE" On line method.
31) Scroll between 2 available selections: "ON.L INE" or "MANUAL" for
the configuration option of your choice. If your choice of selection is
"MANUAL", skip to Step 40).
32) Display stops flashing and shows "ON.L INE".
33) Display shows "INPUt 1" Item #1 of coordinate #1.
Pressing 'RESET/ENTER' to sequence through
"INPUt 1", Input 1 's value
"REAd 1", Read 1 's value
"INPUt 2", Input 2 's value
"REAd 2", Read 2 's value
headings for the desired selection to enter new value.
34) Display shows "xxxxxx" some 6-digit number, represents the value of
"INPUt 1" as taken from live input source measurement for desired value.
35) Display shows "REAd 1" Item #2 of coordinate #1.
36) Display shows "xxxxxx" some 6-digit number with first digit flashing,
represents the value of "REAd 1" item #2 of coordinate #1.
/MIN' 37) Use 'MAX' and 'MIN' buttons to enter new value of "REAd 1".
38) Display shows "INPUt 2" Item #1 of coordinate #2. Continue to
proceed with the selection and value entry for "INPUt 1" and "REAd 1"
for "INPUt 2" and "REAd 2", (item #1 and #2 of coordinate #2) similar to
steps above.
39) Display advances to "MP.SC.OF" Multi-Scale & Offset configuration
menu. If "REAd 2" item #2 of coordinate #2 was prompted or modified, the
controller will also show "StOREd" stored message momentarily.
40) "MANUAL" heading stops flashing.
41) Display shows "INPUt 1" Item #1 of coordinate #1.
Pressing 'RESET/ENTER' to sequence through
"INPUt 1", Input 1 's value
"REAd 1", Read 1 's value
"INPUt 2", Input 2 's value
"REAd 2", Read 2 's value
headings for the desired selection and continue using 'MAX' and 'MIN'
buttons to manually enter or modify the values as described the below
section.
42) Display shows "xxxxxx" some 6-digit number with first digit flashing,
represents the value of "INPUt 1" item #1 of coordinate #1.
/MIN' 43) Use 'MAX' and 'MIN' buttons to enter new value of "INPUt 1" item #1
of coordinate #1.
44) Display shows "REAd 1". Continue with the sequential items and use
'MAX' & 'MIN' buttons to select and enter values.
45) Display advances to "MP.SC.OF" Multi-point Scale & Offset
Configuration Menu. If "REAd 2" item #2 of coordinate #2 was prompted
or modified, the controller will also shows "StOREd" stored message
momentarily.
16
63