16
Input Configuration Menu
Press 'RESET/ENTER'
Press 'RESET/ENTER'
Press ' /MAX'
Press 'RESET/ENTER'
Press 'RESET/ENTER'
Press ' /MAX'
Press 'RESET/ENTER'
16.4 IN.SC.OF
IN.SC.OF
(Input Scale & Offset)
Press 'RESET/ENTER'
Press ' /MAX'
Press 'RESET/ENTER'
Press ' /MAX'
62
In case of "bRIdGE" input type:
19) Display shows "bRdG.LM" Bridge Limit function menu.
20) Display flashes "NORMAL" or the previous setting.
21) Scroll the available options of setting: "NORMAL" or "SP1.L.2.H"
(Setpoint 1 value would be lower overload limit and Setpoint 2 would be
upper overload limit) for your choice of setting.
22) Display advances to "RAt IO" Ratiometric input reading or
measurement setup menu. If a change was made, the controller will also
show "StOREd" stored message momentarily.
23) Display flashes "dISAbL" or previous setup option.
24) To select either "ENAbLE" or "dISAbL" for your choice of setup.
25) Display advances to "IN.SC.OF" Input Scale & Offset Configuration
Submenu or measurement setup menu. If a change was made, the
controller will also show the "StOREd" stored message momentarily.
Enter INPUT SCALE & OFFSET CONFIGURATION SUBMENU:
ENAbLE
dISAbL
Offset=0
Scale=1
26) Display flashes "dISAbL" (default) or previous selection.
27) To select either "ENAbLE" or "dISAbL" for your choice of setup.
28) Select "ENAbLE", display flashes "ON.LINE" (default) or previous
selection.
29) To select either "ON.LINE" or "MANUAL" for your choice of Input
Scale & Offset Configuration.
ON.LINE
INPUt 1
(Input 1 value)
REAd 1
(Read1 value)
INPUt 2
(Input 2 value)
REAd 2
(Read 2 value)
MANUAL
INPUt 1
(Input 1 value)
REAd 1
(Read1 value)
INPUt 2
(Input 2 value)
REAd 2
(Read 2 value)