Omega DP41-B User Manual page 64

Universal input meter
Hide thumbs Also See for DP41-B:
Table of Contents

Advertisement

14
Reading Configuration Menu
Press 'RESET/ENTER'
Press 'RESET/ENTER'
Press 'RESET/ENTER'
Press ' /MAX' & '
Press 'RESET/ENTER'
Press 'RESET/ENTER'
MANUAL
Press 'RESET/ENTER'
Press 'RESET/ENTER'
Press 'RESET/ENTER'
Press ' /MAX' & '
Press 'RESET/ENTER'
Press 'RESET/ENTER'
54
22) Display shows "xxxxxx" some 6-digit number, represents the value of
"INPUt 1" as taken from live input source measurement for desired value.
23) Display shows "REAd 1" Item #2 of coordinate #1.
24) Display shows "xxxxxx" some 6-digit number with first digit flashing,
represents the value of "REAd 1" item #2 of coordinate #1.
/MIN'
25) Use 'MAX' and 'MIN' buttons to enter new value of "REAd 1".
26) Display shows "INPUt 2" Item #1 of coordinate #2. Continue to
proceed with the selection and value entry, for "INPUt 1" and "REAd 1"
for "INPUt 2" and "REAd 2", (item #1 and #2 of coordinate #2), similar to
steps above.
27) Display advances to "UNt.tMP" Temperature Unit selection Submenu.
If an item # of coordinate # was prompted or modified, the controller will
also show the "StOREd" stored message momentarily.
28) "MANUAL" heading stops flashing.
29) Display shows "INPUt 1" Item #1 of coordinate #1.
Pressing 'RESET/ENTER' to sequence through:
"INPUt 1", Input 1 's value
"REAd 1", Read 1 's value
"INPUt 2", Input 2 's value
"REAd 2", Read 2 's value
headings for the desired selection and continue using 'MAX' and 'MIN'
buttons to manually enter or modify the values as described in the
following section.
30) Display shows "xxxxxx" some 6-digit number with first digit flashing,
represents the value of "INPUt" item #1 of coordinate #1.
/MIN'
31) Use 'MAX' and 'MIN' buttons to enter new value of "INPUt 1" item #1
of coordinate #1.
32) Display shows "REAd 1". Continue the sequential items with 'MAX' &
'MIN' buttons to select and enter values.
33) Display advances to "UNt.tMP" Temperature Unit selection Submenu. If
an item # of coordinate # was prompted or modified, the controller will also
show the "StOREd" stored message momentarily.

Advertisement

Table of Contents
loading

Table of Contents