Omega DP41-B User Manual page 98

26
Communication Menu Configuration
SUM.CHK
Press 'RESET/ENTER'
Press 'RESET/ENTER'
Press ' /MAX'
LN.FEEd
Press 'RESET/ENTER'
Press 'RESET/ENTER'
Press ' /MAX'
ECHO
Press 'RESET/ENTER'
Press 'RESET/ENTER'
Press ' /MAX'
88
14) Display shows "SUM.CHk" Check Sum setting submenu. If necessary
to select the other available following Bus Format Setting submenus:
"LN.FEEd", "ECHO", "StNd", "MODE", and "HNd.SHk", use or press the
'MENU' button.
15) Display flashes "NO" No (checksum excluded) option as default or
previous selection.
16) Scroll through or select either two available options: "NO" to exclude or
"yES" to include the checksum with Input Reading Data.
17) Display shows "StOREd" stored message momentarily and then
advances to the "LN.FEEd" Line Feed setting submenu.
• Line Feed setting determines if data sent from the controller will have a
Line Feed appended to the end or following all <CR>'s – useful for
viewing or logging results on separate lines when displayed on
communications software at a computer.
18) Display flashes "NO" No (Line Feeds excluded) option as default or
previous selection.
19) Scroll through or select either two available options: "NO" to exclude or
"yES" to include the line feeds with Reading Data.
20) Display shows "StOREd" stored message momentarily and then
advances to the "ECHO" Line Feed setting submenu.
• When valid commands are sent to the instrument, this determines
whether the command will be echoed to the Serial Bus. Use of "ECHO"
is recommended in most situations, especially to help verify that data
was received and recognized by the controller.
21) Display flashes "yES" Yes (enable Echo responding from controller)
option as default or previous selection.
22) Scroll through or select either two available options: "yES" to enable
Echo response or "NO" to disable Echo response from Controller to
Serial Bus.