SECTION 4. CONFIGURING THE METER
Note
Refer to Table 6-1 for a summary list of menu configuration.
For first-time users: Refer to the QuickStart Manual for basic operation and
set-up instructions.
4.1 SELECTING THE INPUT TYPE
To select your appropriate input type signal, follow these steps:
Note
Before proceeding, set the input DIP switch settings at the back of your
meter. (Refer to Table 2-3).
Press the MENU button. The meter shows INPT .
1.
Press the ∂TARE button. The meter flashes one of the following:
2.
100M (for 0-100 mV dc) (Default)
•
±50M (for ±50 mV dc)
•
10V (for 0-10 Vdc)
•
±5V (for ±5 Vdc)
•
0-20 (for 0-20 mA dc)
•
Press the ßNT/GRS button to scroll through available choices.
3.
4.
Press the MENU button to store your choice. The meter momentarily shows
STRD , followed by DEC.P (Decimal Point).
Configuring The Meter
INPT
4
21