Omega DP41-B User Manual page 19

BUTTON Function in Configuration Mode
• To enter the Menu, the user must first press 'MENU' button.
• To select "older -style" of Menu Configuration, "MENU 2", press
MENU
• Use this button to advance/navigate to the next menu item. The
• While a parameter is being modified, press this button to escape
• Press this button to access the submenus from a Top Level Menu
• Press this button, to store a submenu selection, or after Entering a
ENTER
• In Menu Configuration Mode, pressing this button repeatedly also
• In the Run Mode, pressing the 'RESET/ENTER' button once erases
• In the Run Mode, pressing 'RESET/ENTER' button twice, will cause
Note
• Reset: Except for Set Points and the Alarms, modifying any settings
• Every Menu underlined item, number, or state is the Factory
• Make certain that the unit has no locked menu Before attempting
'MENU' button while Display is showing Firmware Version Number
and only after applying the power. Use ' /MAX' to select "MENU 2"
or "MENU 1" the default modern Menu Navigation option. Press
'MENU' button again to store your Menu selection.
If "MENU 2" is selected, users will be prompted to choose one
of these three available Display Colors: "GREEN", "AMbER"
or "REd".
user can navigate through all the top-level menus by pressing
"MENU" repeatedly.
without saving the parameter.
item.
selected value/state - the display will flash a "StOREd" message to
confirm your selection.
allow user to sequence and confirm all settings through entire setup
menu items.
the memories of Peak "HI RdG", Valley "LO RdG" reading values,
and Alarm Latches. The display shows "RESEt 1" momentarily then
returns to Run Mode.
a hardware reset, as display shows "RESEt 2".
of the menu configuration will reset ("RESEt 2") the unit prior
to resuming Run Mode.
default/preset value. Example: 001, 002, 004
to locate and configure the specific menu function.
Parts of the Meter
4
9