Ink Collector Unit Contact Switch - Ricoh D124-17 Service Manual

4. Replacement and Adjustment
• The port at [B] is open and will leak ink if the tank is turned on its side or turned upside down.

Ink Collector Unit Contact Switch

Preparation
• Open the ink collector cover and remove the ink collector tank.
• Remove the maintenance unit.
1. The sensor is located at [A].
2. Use the tip of a small screwdriver to release both sides of the sensor [B].
3. Pull the harness and sensor through hole [A].
4. Free the harness [B] (
5. Disconnect and remove the sensor [C] (
Reinstallation
480
page 482
x6).
x1).