Ricoh D124-17 Service Manual page 286

4. Replacement and Adjustment
1. From the back of the machine, remove the three rivet screws [A].
To remove a rivet screw:
• Use a small screw driver to loosen the screw until it raises slightly.
• Remove the rivet with your fingers.
2. From the front, raise the operation panel [B] off the base. Do not remove! There are connectors
attached below the operation panel.
3. At the front, disconnect the operation panel, and then lay it on a flat, clean surface (
4. Remove the plastic base (
USB Board
Preparation
Remove:
• Operation panel
284
x6).
x2).