Ricoh D124-17 Service Manual page 735

1857 Paper Feed Stop Timing (Size4) DFU
This SP code is used to adjust the registration roller stop timing for roll paper Size 4
based on the amount of paper remaining on the roll.
1 Remaining: less than 10%
[0 to 1000/200/1 msec]
2 Remaining: 10< to 20%
[0 to 1000/200/1 msec]
3 Remaining: 20< to 30%
[0 to 1000/200/1 msec]
4 Remaining: 30< to 40%
[0 to 1000/200/1 msec]
5 Remaining: 40< to 60%
[0 to 1000/200/1 msec]
6 Remaining: 60< to 80%
[0 to 1000/200/1 msec]
7 Remaining: 80< to 100%
[0 to 1000/200/1 msec]
1921 Cut Length Adjustment - Cutting Position Adjustment
This SP adjusts the distance between between the DRESS sensor (image registration
sensor) and the first cut position. This setting is no longer used after the 2nd cut during
continuous printing. Cuts once to test the new setting, then once again to do actual cut.
[-10 to 10/0.0/0.1 mm]
Example
• To set a length of 297 mm, with the machine cutting at 300 mm, you need to move
the cutting position 3 mm upstream with a value of -3 mm.
• To set a length of 295 mm, with the machine cutting at 297 mm, you need to move
the cutting position downstream with a value of +2 mm
SP1000
31