Ricoh D124-17 Service Manual page 904

2. Appendix 2: Service Program Mode
Stamp Data Download
Push [Execute] to download the fixed stamp data from the machine ROM onto the hard
disk.
5853
• After downloading these stamps can be used by the system. If this is not done, the
• You must always execute this SP after replacing the HDD or after formatting the
Remote ROM Update
When set to "1" allows reception of firmware data via the local port (IEEE 1284) during
a remote ROM update. This setting is reset to zero after the machine is cycled off and on.
5856
Allows the technician to upgrade the firmware using a parallel cable.
[0 to 1/0/1]
0: Not allowed, 1: Allowed
5857 Save Debug Log
On/Off (1:ON 0:OFF)
Switches the debug log feature on and off. The debug log cannot be captured until this
1
feature is switched on.
0: OFF, 1: ON
Target (2: HDD 3: SD)
Selects the storage device to save debug logs information when the conditions set with
2
SP5-858 are satisfied.
[ 2 to 3/2/1 /step]
2: HDD, 3: SD Card
Save to HDD
Saves the debug log of the input SC number in memory to the HDD.
5
A unique file name is generated to avoid overwriting existing file names on the SD Card.
Up to 4MB can be copied to an SD Card. 4 MB segments can be copied one by one to
each SD Card.
Save to SD Card
6
Saves the debug log of the input SC number in memory to the SD card.
200
user will not have access to the fixed stamps ("Confidential", "Secret", etc.).
HDD. Always switch the machine off and on after executing this SP.
CTL