Software Reset - Ricoh D124-17 Service Manual

9. Wait for 2 to 3 minutes until you see the "Completed" message.
10. Touch [Exit] to exit the SP mode.
• If the machine returns a "Failed" error message, there is no space remaining on the SD card.
Touch [Exit] and then exit the SP mode. Try again with another SD card with sufficient space.
How Files are Named
The SMC list data saved on the SD-card are named automatically using the file naming conventions
described below.
[A| Machine serial number (fixed for each machine)
SP number saved in this file. First four digits (5992) in this part are fixed. The other one or
two digits are the detail SP number(s). In this case, it is one digit. Therefore, this file is of
[B]
SP5992-001 (All data list). See the upper SP table for the correspondence between SP
detail numbers and the contents.
[C] File creation date. YY/MM/DD ("0" is omitted if each is one digit.)
[D] File creation time. HH/MM/SS (0)" is omitted if each is one digit.)
[E] File Extension CSV (Comma Separated Value). This part is fixed.
• A folder named using the machine serial number will be created on the SD card.
• This function can save the SMC list data only to an SD card inserted into the operation panel SD
card slot.

Software Reset

This software reset is the same as turning the machine off on and with the main power switch, but it is
much faster.
1. Hold down and
2. When the machine beeps once, release both buttons.
together for 10 seconds.
System Maintenance Tasks
581