Ricoh D124-17 Service Manual page 65

2. Set the two center stays between the left and right supports.
3. Make sure that the pattern of clustered cutouts [A] are down.
4. Engage the ends of the stays on the ends of both stays.
5. Insert and finger-tighten the end of each stay to the left and right supports (
the hex-head bolts until all have been inserted.)
6. After all the bolts have been inserted and slightly tightened, use the Allen key to tighten all the bolts.
( x16)
Main Machine Installation
x16). (Do not tighten
63