4. Disconnect the board (
• Screws [1], [2], and [3] are post screws. Each holds one of the screws to attach the MCU in
front of the IPU.
• Remove and reattach each post screw with fingers. The screw should be finger-tight only (not
tightened with a wrench).
5. Remove the IPU and lay it on a flat clean surface.
HRB
Preparation
• Move the Carriage Unit with SP2102-4
• Separate the Main Unit from the Scanner Unit
Remove:
• Top cover
page 219
• Front cover
page 220
• Paper exit guide
page 222
x8).
page 227
page 205
Boards, HDD
509