Ricoh D124-17 Service Manual page 80

2. Installation
5. While holding the unit with both hands:
• Set the positioning pins on the left and right ends of the roll feed unit into the cut-outs in the
supports
• Push the roller unit in.
• Slide it slightly to the right to lock the unit in place.
6. Behind the stand on both sides, make sure that the holes of the roll feed unit and the stand frame
are aligned.
7. Insert the tip of a long screwdriver (30 cm: 12 in.) through each pair of holes to make sure that they
are aligned.
8. Pull the harness over the top of the roll unit to the rear.
9. Fasten the roll feed unit to the stand (
attached.)
78
x4 M3x8). (Be sure to use the screws with the washers