Viewing Participant Properties; Participant Control - Polycom 3150-16966-002 User Manual

Chapter 9 – Conference/Participant Monitoring
Parameter
FECC Token
Content Token

Viewing Participant Properties

To view detailed parameters of a participant, double-click the desired
participant in the participant list, or right-click the participant, and then click
Participant Properties.
The parameters displayed on the General, Advanced and Information tab pages
are the same as those for adding a new participant. For explanation on
configuration parameters, see Adding a Participant to the Local Directory.
The Connection Status tab shows the status and detailed information of the
participants, including time of connecting / disconnecting, cause of
disconnecting, network transfer rate, packet loss ratio, audio, video, etc.
In the Multimedia Settings tab page, you can set whether to mute, block, or
suspend a participant or not.

Participant Control

You can control and modify the participant's connection status of an ongoing
conference through the buttons in the Participant list pane, the Participant
right-click shortcut menu, and the Participant Properties interface.
The table below explains all the buttons in the Participant list pane.
Table 9-4
Button
9-8
Description
The participant has the Far End Camera Control (FECC)
Token and is capable of conducting FECC.
FECC Token can only be allocated to one participant at one
time. If no partipant uses the FECC function, this icon is not
displayed.
The participant is sending dual streams.
Buttons in the Participant List Pane
Name Description
Define a new participant. For more information about
New
the New Participant dialog box, see Creating a
Participant
Participant in the Address Book.
Connect a disconnected defined dial-out participant to
Connect
the conference.
Participant
Disconnect
Disconnect the participant from the conference.
Participant
Delete
Delete the selected participants from the conference.
Participant
Mute the audio transmission from the participant to the
conference. The Audio Muted indicator appears in the
Mute Audio
Participants List and the Unmute Audio button becomes
active (
Participant's audio transmission to the conference
Unmute Audio
resumes. The Mute Audio button becomes active (
).
).