Polycom 3150-16966-002 User Manual page 23

Chapter 2 – First Time Installation and Configuration
Parameter
Remote IP
Address
Subnet Mask
4
5
Figure 2-9
Table 2-3
Parameter
IP Network Type
Register to Gatekeeper
Primary (Alternate)
Gatekeeper
Gatekeeper IP Address
Gatekeeper Port
System Prefix/E164.
2-8
Description
Set the target network address for packet transmission.
Set the subnet mask for the target network.
If your IP network type is SIP only, go to step 7.
To register the system to the gatekeeper, click the Gatekeeper tab, and
configure related parameters in accordance with the table below:
IP Network Services – Gatekeeper
Gatekeeper Setting
Description
Set the IP network type for the RMX 1000 system to
make a call. You need to set it based on the call type
used for the participant's endpoint. It can be set to:
Settings of the gatekeeper related parameters are
available only when the H.323 network type is selected.
Set whether or not to register with the gatekeeper. You
must check this option to set the parameters that follow.
Indicates whether or not the device is registered with the
primary (or alternate) gatekeeper.
Set the IP address for the primary (or alternate)
gatekeeper.
The port number for the primary (or alternate)
gatekeeper.
Set the E.164 number for the system.
H.323: Only H.323 calls are supported.
SIP: Only SIP calls are supported.
H.323 & SIP: H.323 and SIP calls are supported at
the same time.