Polycom 3150-16966-002 User Manual page 24

Parameter
System H.323 Alias
If your IP network type is H.323 only, go to step 8.
6
To configure the SIP server, click the SIP Server tab, and configure
7
related parameters in accordance with the table below:
Figure 2-10 IP Network Services –SIP Server
Table 2-4 Configuration Description of SIP Server Parameters
Parameter
IP Network Type
Transport Type
Register to Server
Primary
Server/Alternate
Server
Description
Set the H.323 alias for the system.
Description
Set the IP network type for the RMX 1000 system to make
a call. You need to set it based on the call type used for the
participant's endpoint. It can be set to:
H.323: Only H.323 calls are supported.
SIP: Only SIP calls are supported.
H.323 & SIP: H.323 and SIP calls are supported at the
same time.
Settings of the SIP server related parameters are available
only when the SIP network type is selected.
Set the transport layer protocol used for communicating
with the SIP server. It needs to be consistent with the
protocol supported by the SIP server.
Specifies whether to register RMX 1000 to the specified
SIP server. You need to set the SIP server related
parameters after this function is enabled.
Displays the registration status of the SIP server.
When registration of the preferred server fails, the
alternate server will function as the current in-use SIP
server.
Polycom RMX 1000 User Guide
2-9