Polycom 3150-16966-002 User Manual page 101

Chapter 11 – IP Service Settings
Figure 11-5
Table 11-4
Parameter
IP Network Type
Transport Type
Register to Server
Primary
Server/Alternate
Server
Server Address
11-6
IP Service – SIP Server
Configuration Description of SIP Server Parameters
Description
Set the IP network type for the RMX 1000 system to make
a call. You need to set it based on the call type used for the
participant's endpoint. It can be set to:
H.323: Only H.323 calls are supported.
SIP: Only SIP calls are supported.
H.323 & SIP: H.323 and SIP calls are supported at the
same time.
Settings of the SIP server related parameters are available
only when the SIP-supporting network type is selected.
Set the transport layer protocol used for communicating
with the SIP server. It needs to be consistent with the
protocol supported by the SIP server.
Specifies whether to register RMX 1000 to the specified
SIP server. You need to set the SIP server related
parameters after this function is enabled.
Displays the registration status of the SIP server.
When registration of the preferred server fails, the
alternate server will function as the current in-use SIP
server.
Provides the IP address of SIP server for registration
service.