Teltonika RUT955 User Manual page 71

RUT955 User's Manual
10. Override MTU
7.2.2.2.3 PPPoE
For the PPPoE protocol you can turn NAT on or off, specify custom DNS servers, define the gateway metric,
configure LCP echo settings and more. You will find additional information on how to define these settings bellow.
Field name
1. Disable NAT
2 Use default gateway
3. Use gateway metric
4. Use DNS servers
advertised by peer
5. Use Custom DNS
Servers
5. LCP echo failure
threshold
6. LCP echo interval
7. Inactivity timeout
Teltonika Solutions
1500 Maximum Transmission Unit (MTU) – specifies the largest
possible size of a data packet
Sample value Explanation
Enable/Disable Toggle Network Address Translation (NAT) on or off for the
selected network interface
Enable/Disable If left unchecked, no default route is configured
0 The WAN configuration by default generates a routing table
entry. In this field you can alter the metric of that entry
Enable/Disable If left unchecked, the advertised DNS server addresses are
ignored
8.8.8.8 Lets you chose you own preferred DNS servers
8.8.4.4
0 Presume peer to be dead after given amount of LCP echo failures.
Leave it at 0 to ignore failures
5 Send LCP echo requests at the given interval in seconds. This
function is only effective in conjunction with failure threshold
0 Close inactive connection after the given amount of seconds.
Leave it at 0 to persist connection
71