Routing; Static Routes - Teltonika RUT955 User Manual

RUT955 User's Manual

7.7 Routing

7.7.1

Static Routes

Static routes specify over which interface and gateway a certain host or network can be reached. In this page you
can configure your own custom routes.
Field name
1. Routing table
2. Interface
3. Destination
address*
4. Netmask*
5. Gateway
6. Metric
*Additional notes on Destination & Netmask:
You can define a rule that applies to a single IP like this: Destination - some IP; Netmask - 255.255.255.255.
Furthermore, you can define a rule that applies to a segment of IPs like this: Destination – some IP that STARTS the
segment; Netmask – Netmask that defines how large the segment is. e.g.:
192.168.55.161 255.255.255.255
192.168.55.0 255.255.255.0
192.168.55.240 255.255.255.240
192.168.55.161 255.255.255.0
192.168.0.0 255.255.0.0
Teltonika Solutions
Possible values
MAIN/WAN/WAN2/WAN3 Defines which table will be used for the route in question
MAIN/WAN/WAN2/WAN3 The zone where the target network resides
IP address
IP mask
IP address
integer
Only applies to 192.168.55.161
Applies to IPs in the 192.168.55.0 - 192.168.55.255 range
192.168.55.240 - 192.168.55.255
192.168.55.0 - 192.168.55.255
192.168.0.0 - 192.168.255.255
Explanation
The address of the destination network
Mask that is applied to the Target to determine to what actual
IP addresses the routing rule applies
Where the router should send all the traffic that applies to the
rule
Used as a sorting measure. If a packet about to be routed fits
two rules, the one with the higher metric is applied
102