Teltonika RUT955 User Manual page 70

RUT955 User's Manual
7.2.2.2.2 DHCP
For the DHCP protocol you can turn NAT on or off, specify custom DNS servers, define the gateway metric, override
the router's MAC address, set MTU and more. You will find additional information on how to define these settings
bellow.
Field name
1. Disable NAT
2 Use broadcast flag
3. Use default gateway
4. Use DNS servers
advertised by peer
5. Use custom DNS
Servers
6. User gateway metric
7. Client ID to send when
requesting DHCP
8. Vendor Class to send
when requesting DHCP
9. Override MAC address
Teltonika Solutions
Sample value Explanation
On/Off Toggle Network Address Translation (NAT) on or off for the
selected network interface
Enable/Disable Required for certain ISPs, e.g. Charter with DOCSIS 3
Enable/Disable If left unchecked, no default route is configured
Enable/Disable If left unchecked, the advertised DNS server addresses are
ignored
8.8.8.8 Lets you chose your own preferred DNS servers
8.8.4.4
0 The WAN configuration by default generates a routing table
entry. In this field you can alter the metric of that entry
Client ID which will be sent when requesting a DHCP lease
Vendor class which will be sent when requesting a DHCP lease
00:51:33:77:56:17 Override MAC address of the WAN interface. If your ISP gives
you a static IP address it might also bind it to your computers
MAC address (i.e. that IP will only work with your computer but
not with your router). In this field you can enter your computer's
MAC address and fool the gateway in to thinking that it is
communicating with your computer
70