Override - Tork DZS200 Installation & Operation Manual

NOTE: If you have just finished setting the unit and
an output is to be presently on, press the OVER-
RIDE key to turn it on. The timer will take control
from that moment on.

13.0 OVERRIDE

Press OVERRIDE to change the output status from Off
to On or vice versa. The output will stay in that condi-
tion until the next scheduled event.
Example: The channel is scheduled off at 5:00 PM.
The office cleaning personnel arrive at 6:00 PM and
press the OVERRIDE key to turn the lights on. You
know in the past they are finished by 7:30 PM. You
have therefore scheduled an additional Off at 8:00PM.
If the cleaning crew forgets to turn off the lights, they
would be turned off at 8:00 PM by the timer.
When a channel is used for signal operation, the over-
ride may be used for testing of fire bells or horns, or for
actual fire conditions where the bell or horn is left on
for the duration of the emergency.
NOTE: When OVERRIDE is pressed for a signal chan-
nel, the output will still remain constantly On. Press the
key again to turn Off.
30