To Set Channel For Sunset On/ Sunrise Off - Tork DZS200 Installation & Operation Manual

Press RUN/SET to go to the Run mode when
scheduling is complete.
6.0 TO SET CHANNEL FOR SUNSET ON/
SUNRISE OFF
CAUTION: MAKE SURE THAT YOU HAVE SET THE
Press the RUN/SET key until the TIME/DAY symbol
begins to flash. Press the ADVANCE until the LATI-
TUDE symbol begins to flash. The display shows
TIME/DAY
17
E
SIG. TIMER
SCH/RVU
Press ENTER.
The digits for degrees are flashing. Press ADVANCE
to set the latitude where you are. Check your news-
paper or local weather bureau for your latitude.
NOTE: If none of the above sources are available,
use the map on the next page to figure out
your approximate latitude.
To set southern latitudes for below the equator, contin-
ually press ADVANCE until the latitude indicator
changes from "Ln" to "LS". When the displayed latitude
information is correct, press ENTER to store it.
"C1" is flashing. If you want astronomic (sunrise/sun-
set) operation on channel 1, press ENTER. If not,
press ADVANCE to flash channel 2. Press ENTER to
select that channel for astronomic operation.
TIME/DAY
18
SIG. TIMER
SCH/RVU
PROPER DATE BEFORE PROCEEDING.
SU MO TU WE TH FR SA H1 H2
DATE
SCH. ON OFF
SIGNAL A B
SU MO TU WE TH FR SA H1 H2
DATE
SCH. ON OFF
SIGNAL A B
SET
SET
18
HOLIDAY
LATITUDE
SUNSET
SUNRISE
HOLIDAY
LATITUDE
SUNSET
SUNRISE