To Set Standard On/Off Schedule - Tork DZS200 Installation & Operation Manual

NOTE: Since daylight savings was previously set, we
have to review the block holiday entries to find it and
modify it.
Press ENTER continuously until the daylight savings
start date is displayed with a bar over the ON symbol.
9
E
While RVU is flashing, press ADVANCE twice. The
month digits will begin to flash and RVU will stop flash-
ing. Press ADVANCE to modify the start month. Press
ENTER.
The date digits are flashing. Press ADVANCE to
change it. Press ENTER.
The daylight savings end date is now displayed and
RVU flashes again. To change it, press ADVANCE
twice. The month digits will begin to flash and RVU will
stop flashing. Press ADVANCE to modify the end
month if necessary. Press ENTER.
The date digits are flashing. Press ADVANCE to modi-
fy it. Press ENTER.
Press RUN/SET to exit to the Run mode.

4.0 TO SET STANDARD ON/OFF SCHEDULE

From the Run mode press the RUN/SET key to go to
the Set modes. Press ADVANCE until the SCH/RVU
symbol is flashing (in lower left corner of display). The
display shows
10
SIG. TIMER
SU MO TU WE TH FR SA H1 H2
TIME/DAY
DATE
SIG. TIMER
SCH/RVU
SCH. ON
SIGNAL A
SU MO TU WE TH FR SA H1 H2
TIME/DAY
DATE
SCH/RVU
SCH. ON
SIGNAL A
RVU
OFF
B
OFF
B
11
HOLIDAY
LATITUDE
SUNSET
SUNRISE
SET
HOLIDAY
LATITUDE
AM
SUNSET
SUNRISE
SET