If you want to program an offset to the displayed time,
press ENTER. Press ADVANCE to set the offset min-
utes as before. Press ENTER.
Press RUN/SET when complete to exit to the Run
mode.
6.1 TO SET CHANNEL FOR SUNSET ON/TIME OFF
Follow the preceding directions outlined in section 6.0
to set the channel for astronomic (sunset/sunrise)
operation. This will set the sunset ON time.
Next follow the directions outlined in section 4.0 to set
the time OFF desired.
NOTE: When RVU is flashing, simply press
ADVANCE to proceed. Review will be dis-
cussed later.
NOTE: Do not set a morning off time after 2:30 AM for
latitudes greater than 50 degrees.
Example for Sections 6.0 and 6.1: A company in
N.Y.C. want its parking lot lights (on channel 1) to go
on 10 minutes before sunset and off at 12:30 AM.This
is to occur everyday including holidays.
First we want to set the channel to turn ON at sunset.
Press RUN/SET. The TIME/DAY symbol flashes.
Press ADVANCE 5 times. LATITUDE symbol flashes.
Press ENTER. Latitude digits begin to flash.
Press ADVANCE until latitude shows 41° North.
Press ENTER. "C1" flashes.
Press ENTER. The bar under Sunday flashes.
Press ENTER 9 times to select all days and H1 and
H2. LATITUDE symbol flashes again.
Press ADVANCE. Sunset symbol flashes and sun-
set time is displayed.
Press ENTER. Digits for sunset offset flashes. "+" is
shown in front of it.
Press ADVANCE until the display shows "-10".
Press ENTER. Sunset symbol flashes again.
Next we will program the 12:30 AM OFF.
21