Tork DZS200 Installation & Operation Manual page 3

TIME/DAY
DATE
SIG. TIMER
SCH/RVU
SIGNAL
DZS 200
GND
INPUT
VOLTAGE
NOTE: ON schedule – C and N/O contacts close
Use separate dedicated circuit
for Timer and make certain unit
is grounded.
KEY DEFINITIONS:
RUN/SET key
ENTER key
ADVANCE key
Dimensions:
4-17/32" D x 9-5/8" H x 6" W.
KO's bottom, sides, and back 1/2" and 3/4"
SU MO TU WE TH FR SA H1 H2
DLT RVU
SCH. ON OFF
A B
OVERRIDE OVERRIDE
CH 1
RUN/SET ENTER ADVANCE
LI NEUT N/O C N/C
CHANNEL #1 CHANNEL #2
OFF schedule – C and N/C contacts close
(1) Transfers the unit from the RUN
(2) Directly exits from anywhere in
(1) Selects any flashing symbol on
(2) Stores programmed information
(1) Advances flashing symbol to the
(2) Increments any displayed digit.
HOLIDAY
LATITUDE
AM
PM
SUNSET
SUNRISE
SET
CH 2
TORK
N/O C N/C
mode to the SET modes.
the SET modes to the RUN mode.
the display.
into memory.
next selection.
3
To clear all memory,
see Power-Up Check
on page 6.
To remove unit, push
tab to right, swing unit
to left and remove.
Dimensions:
3-5/8" D X 9-5/8" H x 5
KO's bottom and sides
1/2" and 3/4"
CAUTION:
DO NOT USE TOP KO
Use separate dedicate
for Timer and make ce
is grounded.