To Change Time And Day; To Set Date - Tork DZS200 Installation & Operation Manual

The bar under H2 is flashing. Press ADVANCE to pass it.
NOTE: Setting Holiday Dates will be covered in section 7.0.
The TIME/DAY symbol is flashing again. Press
ADVANCE to go to the Date mode or RUN/SET to go
to the Run (Operating) mode.
NOTE: You can press the RUN/SET key at any time
to quickly switch from the Set modes to the Run mode,
or vice versa.

1.1 TO CHANGE TIME AND DAY

Press the RUN/SET key once if in the Run mode or
twice if in another mode. The TIME/DAY symbol will
flash. Press ENTER.
The hour digits flash. Press the ADVANCE key to
modify the hour. Press ENTER.
The minutes flash. Press the ADVANCE key to modify
the minutes. Press ENTER.
The bar under Sunday flashes. Press ADVANCE to
select the current day, if not Sunday. Press ENTER.
The bar under H1 flashes. Press ADVANCE twice to
pass H1 and H2.
The TIME/DAY symbol is again flashing. Press
ADVANCE to proceed to another mode or RUN/SET
to go to the Run mode.

2.0 TO SET DATE

From the Run mode, press the RUN/SET key. The
TIME/DAY symbol will start flashing. Press the
ADVANCE key until the DATE symbol begins to flash.
The display will show
TIME/DAY
2
SIG. TIMER
SU MO TU WE TH FR SA H1 H2
DATE
SCH/RVU
SCH. ON
SIGNAL A
OFF
B
7
HOLIDAY
LATITUDE
SUNSET
SUNRISE
SET