Page 1
TORK MODEL DZM200A 2 CHANNEL DIGITAL TIME SWITCH WITH MOMENTARY CONTACT INSTALLATION & OPERATION CAPABILITIES 365 Day Advance Single Holiday and Seasonal Scheduling. ON and OFF set points: Combined total for both channels - 99 per week Minimum setting - 1 minute Capable of different schedules each day of the week.
TABLE OF CONTENTS Section Description Page Instructions For Installation ......4 To Set The Clock ........5 To Modify Clock (After Previously Set) ..6 To Set Date ..........6 To Modify Date (After Previously Set)..6 Daylight Saving Time .........7 Season Duration Settings ......7 Holiday Dates..........8 Scheduling ON’s, OFF’s ......9 To Set Astronomic ........11...
INSTRUCTIONS FOR INSTALLATION 1. Remove unit from enclosure by pushing the inside tab (located near the outside hasp) to the right. Swing unit to left and remove. 2. Five combination 1/2” and 3/4” knockouts are pro- vided on this enclosure. Remove the 1/2” (inner) knockout by inserting a screwdriver in the slot pro- vided and pound screwdriver handle with a ham- mer.
WE SUGGEST YOU MAKE COPIES OF THE SCHED- ULE SHEETS LOCATED IN BACK OF THIS BOOKLET AND COMPLETE THEM PRIOR TO SETTING THE UNIT. INSTRUCTIONS FOR SETTING THE UNIT Connect unit to main power source prior to entering the settings. First time power up - display shows 12HR Press ENTER.
Press MIN to advance the time in minutes to desired setting. Press DAY key to advance to today’s day. When present hour, minute and day are shown, press ENTER. 1.1 TO MODIFY THE CLOCK (If the unit was already running the program, then unit will show the day of the week, hours, minutes).
3.0 DAYLIGHT SAVING TIME This unit is already set for automatic DAYLIGHT SAVING adjustment. If this is desired, you can proceed to section 4.0 by pressing mode key. Display will show To eliminate daylight saving adjustment, press ON/OFF key. Display should show Press ENTER.
Press MODE key till display shows SEASON Unit is ready to be programmed for starting MONTH and DATE for season 1. Press MONTH and DATE keys to set MONTH and DATE for starting of season 1. Press ENTER. Display now shows SEASON Use MONTH and DATE key to set ending MONTH and DATE for season 1.
NOTE: A total of 24 individual holiday dates can be set. Each holiday is set by MONTH and DATE. The same sched- ule will repeat on every holiday date. Press MONTH key to advance to desired month. Press DATE key to advance to desired date. Press ENTER.
Page 9
NOTE: Duration for each season should have been already established. Now you are ready to begin setting the schedules. There are a total of 99 ON/OFF events. 6.1 CHANNEL SELECTION Press SELCT key to toggle between channel 1 and channel 2. When desired channel flashes, begin setting hours and minutes.
This means unit is ready to accept 2nd schedule entry. Use same procedure to set more SCHEDULES for channel 1. When you are finished setting schedules for chan- nel 1, press SELCT key at the next blank sched- ule screen and CH2 will flash. You can now begin setting schedules for channel 2.
Select the day(s) and/or season(s) in which you want the indicated channel to turn ON at sunset. This is done in the same way as section 6.3 “a.” and 6.3 “b.” using DAY key and SELCT key. If you want the load to come on after or before ÷...
To set a time OFF during the night and/or a time ON before sunrise, proceed as follows: Press MODE key until schedule 01 appears Press ENTER key repeatedly until the next blank schedule screen appears. Use SELCT key to select Channel 1 or Channel 2 (whichever one is to be set for time ON or OFF during the night).
6. SCHEDULE MODE: Schedule review, modify, delete. You can modify the schedule entry using HOUR, MIN, ON/OFF key and SELCT key. Press ENTER after each modification. To delete, simply press the DLETE key when unwanted information is on display. This will blank the entry.
Units do not have stagger start. Clear all memory. All memory can be cleared using the following procedure: while in the RUN mode, press Enter key, display shows: Use ON/OFF key to display: Now press ENTER briefly and everything in the timer memory is wiped off including real time and date.
TORK ® ASTRONOMIC LATITUDE ZONES WASHINGTON MONTANA NORTH DAKOTA 45° MINN MICHIGAN MAINE WISCONSIN SOUTH DAKOTA 42° OREGON IDAHO WYOMING IOWA NEW YORK MASS NEBRASKA RHODE ISLAND 40° PENNSYLVANIA ILLINOIS OHIO CONNECTICUT NEVADA UTAH COLORADO NEW JERSEY WEST KANSAS VIRGINIA 38°...