Advertisement
Table of Contents
- 1 Table of Contents
- 2 Capabilities and Features
- 3 Installation Instructions
- 4 Instructions for Setting the Unit
- 5 Dts200B - Dzs200Bp 3/8/07 9:16 am
- 1 1 To Set the Clock
- 2 2 To Set Date
- 3 3 Daylight Saving Time
- 4 4 Season Durations Settings
- 5 5 Holiday Dates
- 6 6 To Set Signal Durations
- 7 7 Scheduling Ons, Offs and Signal Durations
- 8 8 To Set Astronomic Schedule
- Download this manual
Advertisement
Table of Contents
Need help?
Do you have a question about the DTS200B and is the answer not in the manual?
Questions and answers
The lights stay on continuously
The lights may stay on continuously in the Tork DTS200B for the following reasons:
1. Override Mode: If the override key was pressed, the channel (CH#) may be in override mode, keeping the load (lights) on. The display will flash CH# when overridden.
2. No Scheduled Event: If no ON/OFF schedule is programmed, the lights will not turn off automatically.
3. Last Scheduled Event Execution: After a power failure, the unit executes the last scheduled event. If the last event was turning the lights on, they will stay on until the next scheduled OFF event.
4. Holiday or Seasonal Setting: If a holiday or seasonal schedule is active, the lights may remain on based on preset dates.
5. Sunrise Offset Setting: If an offset to sunrise is set incorrectly, the lights may stay on longer than expected.
To fix this, check the schedule settings, override status, and holiday configurations.
This answer is automatically generated