To Set Time And Day - Tork DZS200 Installation & Operation Manual

7. POWER-UP CHECK: To make sure display
and microprocessor are functioning properly,
press and hold ENTER button as you insert and
remove pin or fine point ballpoint pen in
"RESET"hole in upper right side of front panel.
All segments of display should come ON — see
illustration below.
TIME/DAY
SIG. TIMER
Release button and proceed. This completes the
self diagnostics and also clears all memory.

1.0 TO SET TIME AND DAY

Press the RUN/SET key until the TIME/DAY symbol
begins to flash. The display shows
TIME/DAY
1
SIG. TIMER
SCH/RVU
Press ENTER.
The hour digit is flashing. Press ADVANCE to set the
correct hour. (Note AM/PM.) Press ENTER.
The minutes are flashing. Press ADVANCE to set the
minutes, if needed. Press ENTER.
The bar under SU is now flashing. Press the
ADVANCE key to move the bar to the present day of
the week. Press ENTER.
The bar under H1 is now flashing. Press ADVANCE to
pass it.
SU MO TU WE TH FR SA H1 H2
DATE
SCH/RVU
SCH. ON OFF
SIGNAL A
SU MO TU WE TH FR SA H1 H2
DATE
SCH. ON OFF
SIGNAL A B
DLT RVU
B
SET
6
HOLIDAY
LATITUDE
AM
PM
SUNSET
SUNRISE
SET
HOLIDAY
LATITUDE
AM
SUNSET
SUNRISE