FLIR Quasar Gen III CF-6308 User And Installation Manual page 67

Note:
If the camera is attached to Latitude, motion detection configuration should be done from Latitude Admin
Center, not from the web interface.
To configure motion zone area settings
1. From the Sensitivity drop-down list, select High, Medium, or Low. The camera reacts to slight
changes in motion or brightness in the motion zone when set to High, while the camera reacts to
big changes in brightness or motion when set to Low.
To enable motion settings
1. In the Zone section, click Enable. By default, Enable is not checked.
2. Set the motion detection area by left-clicking the screen and dragging the cursor over the area.
Right-click the detection area to delete the area.
3. Click Save Area.
To enable the Alarm Out function
1. See instructions in the
To enable the Audio Out function
1. In the Handlers section, select the Audio Out checkbox. By default, it is not checked.
2. From the Audio Sound drop-down list, select the number for the audio file that you want to play.
See the Event Handler > Sound
of an event.
3. Click Save.
To define the method to store a snapshot
1. See instructions in the
To record an event
1. See instructions in the
To send email notifications
1. See instructions in the
May 21, 2017
Events Source > Motion Screen
Alarm section.
section to load the audio files that are triggered upon occurrence
Alarm section.
Alarm section.
Alarm section.
CF-6308 Box IP Camera User and Installation Guide
Configuration and Operation
61