FLIR Quasar Gen III CF-6308 User And Installation Manual page 58

Configuration and Operation
9.3.1.4.6 IP Filter
The IP Filter screen is used for restricting access to the camera by allowing or denying specific IP
addresses. It is possible to filter up to 10 IP addresses. The options are Allow, Deny, or NONE (default).
To allow an IP address
1. From the Filter drop-down list, select Allow.
2. Check the Enable checkbox for each IP address for which you want to allow access.
3. Enter the IP address in the Address text box.
4. Click Save.
To deny an IP address
1. From the Filter drop-down list, select Deny.
2. Check the Enable checkbox for each IP address for which you want to deny access.
3. Enter the IP address in the Address text box.
4. Click Save.
9.3.1.4.7 DDNS
The DDNS (Dynamic DNS) screen is used for network access if you select PPPoE as the default network
connection. Before configuring the system to use DDNS, you must first register with a DDNS service
provider.
To use DDNS
1. From the Enable drop-down list, select ON. The default is OFF.
2. From the Type drop-down list, select the DDNS service provider:
· DynDNS:
No-IP:
·
Two-DNS:
·
FreeDNS:
·
3. Enter the Host Name, User Name, and Password in the respective text box.
52
Network > IP Filter Screen
Network > DDNS Screen
custom@dyndns.org
default@no-ip.com
default@two-dns.de
default@freedns.afraid.org
CF-6308 Box IP Camera User and Installation Guide
(default)
May 21, 2017