FLIR Quasar Gen III CF-6308 User And Installation Manual page 10

Document Scope and Purpose
Caution:
Do not drop the camera or subject it to physical shock.
·
· Do not touch sensor modules with fingers. If cleaning is necessary, use a clean cloth with a bit of
ethanol and wipe it gently. If the camera will not be used for an extended period of time, put on
the lens cap to protect the sensor from dirt.
Do not aim the camera lens at strong light, such as the sun or an incandescent lamp, which can
·
seriously damage the camera.
Make sure that the surface of the sensor is not exposed to a laser beam, which could burn out
·
the sensor.
If the camera will be fixed to a ceiling, verify that the ceiling can support more than 20 newtons
·
(20-N) of gravity, or over three times the camera's weight.
The camera should be packed in its original packing if it is reshipped.
·
Caution:
To avoid damage from overheating or unit failure, assure that there is sufficient temperature regulation to
support the unit's requirements (cooling/heating). Operating temperature should be kept in the range --20°
to 50°C (-4° to 122°F), with no more than 90% non-condensing humidity.
Attention:
Afin d'éviter tout dommage dû à une surchauffe ou toute panne de l'unité, assurez-vous que la régulation
de température est suffisante pour répondre aux exigences de l'unité (refroidissement/chauffage). La
température de fonctionnement doit être maintenue dans la plage (-20° à 50°C/-4° à 122°F), sans
condensation d'humidité supérieur à 90%.
4
CF-6308 Box IP Camera User and Installation Guide
May 21, 2017