Ftp Server - FLIR Quasar Gen III CF-6308 User And Installation Manual

Configuration and Operation
To configure the Wire Setting
1. In the Wire Setting section, from the Speed & Duplex drop-down list, select one of the following:
10 Mbps Half Duplex
·
10 Mbps Full Duplex
·
· 100 Mbps Half Duplex
· 100 Mbps Full Duplex
Auto (default setting)
·
To enable UPnP settings
1. In the UPnP section, from the Enable UPnP drop-down list, select ON. The default is ON. This
enables the camera to be detected by any unit on the LAN.
2. From the Mode drop-down list, select one of the following:
IP and Device Name – The camera connects to the UPnP server by using its
·
IP address and default device name. This is the default setting.
Device Name – The camera connects to the UPnP server by using the default
·
camera name.
User Input – The camera connects to the UPnP server by using a friendly
·
name. Enter the name in the Friendly Name text box that opens when this
option is selected:
To enable SSL
1. In the SSL section, from the Enable SSL drop-down list, select ON. The default is OFF.
Note:
You must install or generate an SSL certificate before enabling SSL.

9.3.1.4.2 FTP Server

The camera includes a built-in FTP server which enables remote access to files of events that are captured
in snapshots or recorded on clips and are stored on the camera's microSD card. The FTP Server screen
is used to enable remote access of the camera's microSD card. No configuration of the camera's internal
FTP server is required by the user. The camera's IP address is ftp://<camera IP address>.
46
UPnP User Input Screen
CF-6308 Box IP Camera User and Installation Guide
May 21, 2017