Configure Link Group Interface - Cisco ASR 9000 Series Routing Configuration Manual

Implementing IS-IS
CLNS I/O
IPv4 Unicast Topology:
IPv4 Address Family:
LSP transmit timer expires in 0 ms
LSP transmission is idle
Can send up to 9 back-to-back LSPs in the next 0 ms

Configure Link Group Interface

Perform this task to configure link group under Intermediate System-to-Intermediate System (IS-IS) interface
and address-family sub-mode:
One IS-IS interface and address-family can specify only one link-group association. The default is for
Note
both levels regardless of the current circuit-type. The link-group association can be specified for one level
only if configured.
SUMMARY STEPS
1. configure
2. router isis instance-id
3. interface type interface-path-id
4. address-family ipv4 | ipv6 [ unicast ]
5. link-group link-group-name [ level {1 | 2 } ]
6. commit
7. show isis interface
DETAILED STEPS
Command or Action
Step 1 configure
Protocol State:
MTU:
SNPA:
Layer-2 MCast Groups Membership:
All ISs:
Adjacency Formation:
Prefix Advertisement:
Metric (L1/L2):
Weight (L1/L2):
MPLS Max Label Stack:
MPLS LDP Sync (L1/L2):
Link-Group (L1/L2):
Metric-Offset (L1/L2):100/100
Protocol State:
Forwarding Address(es): 100.5.6.6
Global Prefix(es):
Cisco ASR 9000 Series Aggregation Services Router Routing Configuration Guide, Release 5.3.x
Up
1497
0026.9829.af19
Yes
Enabled
Running
Running
110/110
0/0
1
Disabled/Disabled
Configured/Configured
Enabled
Up
100.5.6.0/24
Purpose
ISIS Link Group
393