Configuring A Static Route Between Pe-Ce Routers: Example; Additional References - Cisco ASR 9000 Series Routing Configuration Manual

Configuring a Static Route Between PE-CE Routers: Example

Configuring a Static Route Between PE-CE Routers: Example
In the following example, a static route between PE and CE routers is configured, and a VRF is associated
with the static route:
configure
router static

Additional References

The following sections provide references related to implementing Static Routes.
Related Documents
Related Topic
Static routes commands: complete command syntax,
command modes, command history, defaults, usage
guidelines, and examples
MPLS Layer 3 VPN configuration: configuration
concepts, task, and examples
Standards
Standards
No new or modified standards are supported by this
feature, and support for existing standards has not
been modified by this feature.
MIBs
MIBs
—
Cisco ASR 9000 Series Aggregation Services Router Routing Configuration Guide, Release 5.3.x
644
vrf vrf_A
address-family ipv4 unicast
0.0.0.0/0 2.6.0.2 120
end
Implementing Static Routes
Document Title
Static Routing Commands in Cisco ASR 9000 Series
Aggregation Services Router Routing Command
Reference
Cisco ASR 9000 Series Aggregation Services Router
MPLS Configuration Guide
Title
—
MIBs Link
To locate and download MIBs using Cisco IOS XR
software, use the Cisco MIB Locator found at the
following URL and choose a platform under the Cisco
Access Products menu: http://cisco.com/public/
sw-center/netmgmt/cmtk/mibs.shtml