Cisco ASR 9000 Series Routing Configuration Manual page 172

Configuring a VPN Routing and Forwarding Instance in BGP
Command or Action
Step 6
remote-as as-number
Example:
RP/0/RSP0/CPU0:router(config-bgp-nbr)# remote-as
1
Step 7
description text
Example:
RP/0/RSP0/CPU0:router(config-bgp-nbr)#
description neighbor 172.16.1.1
Step 8 password { clear | encrypted } password
Example:
RP/0/RSP0/CPU0:router(config-bgp-nbr)# password
encrypted 123abc
Step 9 shutdown
Example:
RP/0/RSP0/CPU0:router(config-bgp-nbr)# shutdown
Step 10 timers keepalive hold-time
Example:
RP/0/RSP0/CPU0:router(config-bgp-nbr)# timers
12000 200
Step 11
update-source type interface-id
Example:
RP/0/RSP0/CPU0:router(config-bgp-nbr)#
update-source gigabitEthernet 0/1/5/0
Step 12
address-family vpnv4 unicast
Example:
RP/0/RSP0/CPU0:router(config-bgp-nbr)#
address-family vpvn4 unicast
Step 13 route-policy route-policy-name in
Example:
RP/0/RSP0/CPU0:router(config-bgp-nbr-af)#
route-policy pe-pe-vpn-in in
Cisco ASR 9000 Series Aggregation Services Router Routing Configuration Guide, Release 5.3.x
142
Purpose
Assigns the neighbor a remote autonomous system
number.
(Optional) Provides a description of the neighbor. The
description is used to save comments and does not affect
software function.
Enables Message Digest 5 (MD5) authentication on the
TCP connection between the two BGP neighbors.
Terminates any active sessions for the specified neighbor
and removes all associated routing information.
Set the timers for the BGP neighbor.
Allows iBGP sessions to use the primary IP address from
a specific interface as the local address when forming an
iBGP session with a neighbor.
Enters VPN neighbor address family configuration mode.
Specifies a routing policy for an inbound route. The
policy can be used to filter routes or modify route
attributes.
Implementing BGP