Chapter 8 Implementing And Monitoring Rib - Cisco ASR 9000 Series Routing Configuration Manual

Implementing and Monitoring RIB
Routing Information Base (RIB) is a distributed collection of information about routing connectivity among
all nodes of a network. Each router maintains a RIB containing the routing information for that router. RIB
stores the best routes from all routing protocols that are running on the system.
This module describes how to implement and monitor RIB on Cisco IOS XR network.
For more information about RIB on the Cisco IOS XR software and complete descriptions of RIB commands
Note
listed in this module, see the Additional References section of this module.
To locate documentation for other commands that might appear during the execution of a configuration
task, search online in the Cisco ASR 9000 Series Aggregation Services Router Commands Master List.
Feature History for Implementing and Monitoring RIB
Release
Release 3.7.2
Release 4.2.0
Release 4.2.1
Release 4.3.0
• Prerequisites for Implementing RIB, page 502
• Information About RIB Configuration, page 502
• How to Deploy and Monitor RIB, page 506
• Configuring RCC and LCC, page 509
Modification
This feature was introduced.
The following features were added:
BGP Prefix Independent Convergence for RIB and FIB support
was added.
BGP-RIB Feedback Mechanism for Update Generation feature
was added.
Cisco ASR 9000 Series Aggregation Services Router Routing Configuration Guide, Release 5.3.x
C H A P T E R
• Route and Label Consistency Checker (RCC and LCC)
8
501