Route Redistribution For Ospfv3: Example; Virtual Link Configured Through Area 1 For Ospfv3: Example - Cisco ASR 9000 Series Routing Configuration Manual

Implementing OSPF
end-policy
OSPFv2
router ospf 1
spf prefix-priority route-policy ospf-priority
area 0
!
area 3
!
area 8
OSPFv3
router ospfv3 1
spf prefix-priority route-policy ospf-priority
area 0
!
area 3
!
area 8

Route Redistribution for OSPFv3: Example

The following example uses prefix lists to limit the routes redistributed from other protocols.
Only routes with 9898:1000 in the upper 32 bits and with prefix lengths from 32 to 64 are redistributed from
BGP 42. Only routes not matching this pattern are redistributed from BGP 1956.
ipv6 prefix-list list1
seq 10 permit 9898:1000::/32 ge 32 le 64
ipv6 prefix-list list2
seq 10 deny 9898:1000::/32 ge 32 le 64
seq 20 permit ::/0 le 128
router ospfv3 1
router-id 10.0.0.217
redistribute bgp 42
redistribute bgp 1956
distribute-list prefix-list list1 out bgp 42
distribute-list prefix-list list2 out bgp 1956
area 1
interface GigabitEthernet 0/2/0/0

Virtual Link Configured Through Area 1 for OSPFv3: Example

This example shows how to set up a virtual link to connect the backbone through area 1 for the OSPFv3
topology that consists of areas 0 and 1 and virtual links 10.0.0.217 and 10.0.0.212:
endif
interface GigabitEthernet0/3/0/0
!
interface GigabitEthernet0/2/0/0
!
interface GigabitEthernet0/2/0/0.590
interface GigabitEthernet0/3/0/0
!
interface GigabitEthernet0/2/0/0
!
interface GigabitEthernet0/2/0/0.590
Cisco ASR 9000 Series Aggregation Services Router Routing Configuration Guide, Release 5.3.x
Route Redistribution for OSPFv3: Example
495