If-Policy-In; If-Policy-Out; Redistribute - Cisco ASR 9000 Series Routing Configuration Manual

Attach Points
The following example shows the command under EIGRP:
router eigrp 100
address-family ipv4
route-policy global-policy-out out
.
.
.

If-Policy-In

The if-policy-in attach point allows you to filter routes received on a particular EIGRP interface. The following
example shows an inbound policy for GigabitEthernet interface 0/2/0/3:
router eigrp 100
address-family ipv4
interface GigabitEthernet0/2/0/3
.
.
.

If-Policy-Out

The if-policy-out attach point allows you to filter routes sent out on a particular EIGRP interface. The following
example shows an outbound policy for GigabitEthernet interface 0/2/0/3:
router eigrp 100
address-family ipv4
interface GigabitEthernet0/2/0/3
.
.
.

Redistribute

The redistribute attach point in EIGRP allows you to filter redistributed routes from other routing protocols
and modify some routing parameters before installing the route in the EIGRP database. The following example
shows a policy filter redistribution of RIP routes into EIGRP.
router-policy redistribute-rip
if destination in (100.1.1.0/24) then
set eigrp-metric 5000000 4000 150 30 2000
else
set tag 200
endif
end-policy
router eigrp 100
address-family ipv4
redistribute rip route-policy redistribute-rip
.
.
.
Cisco ASR 9000 Series Aggregation Services Router Routing Configuration Guide, Release 5.3.x
602
route-policy if-filter-policy-in in
route-policy if-filter-policy-out out
Implementing Routing Policy