How To Configure Bgp Flowspec - Cisco ASR 9000 Series Routing Configuration Manual

How to Configure BGP Flowspec

BGP Flowspec Controller
The Controller is configured using CLI to provide that entry for NRLI injection.
BGP Flowspec Configuration
• BGP-side: You must enable the new address family for advertisement. This procedure is applicable for
• Controller-side: This includes the policy-map definition and the association to the ePBR configuration
How to Configure BGP Flowspec
Use the following procedures to enable and configure the BGP flowspec feature:
•
•
•
•
Cisco ASR 9000 Series Aggregation Services Router Routing Configuration Guide, Release 5.3.x
212
both the Client and the Controller.
Client-side: No specific configuration, except availability of a flowspec-enabled peer.
consists of two procedures: the class definition, and using that class in ePBR to define the action. The
following topics explain the procedure:
• Define Policy Map, on page 215
• Define Class, on page 214
• Link Flowspec to PBR Policies , on page 217
Enable Flowspec on BGP Side, on page 213
Define Class, on page 214
Define Policy Map, on page 215
Link Flowspec to PBR Policies , on page 217
Enable Flowspec on BGP Side, on page 213
Implementing BGP Flowspec
explains the procedure.