Configuring An Eigrp Authentication Keychain: Example; Additional References - Cisco ASR 9000 Series Routing Configuration Manual

Configuring an EIGRP Authentication Keychain: Example

Configuring an EIGRP Authentication Keychain: Example
The following example shows how to configure an authentication keychain for an IPv4 interface on a nondefault
VRF:
config
router eigrp 100
vrf vrf1
address-family ipv4
interface POS 0/1/0/0
authentication keychain key1
The following example shows how to configure an authentication keychain for an IPv6 interface on a default
VRF:
config
router eigrp 100
address-family ipv6
interface POS 0/1/0/0
authentication keychain key2

Additional References

The following sections provide references related to implementing EIGRP.
Related Documents
Related Topic
EIGRP commands: complete command syntax,
command modes, command history, defaults, usage
guidelines, and examples
MPLS VPN support for EIGRP feature information
Site of Origin (SoO) support for EIGRP feature
information
Cisco ASR 9000 Series Aggregation Services Router Routing Configuration Guide, Release 5.3.x
338
log-neighbor-changes
log-neighbor-warnings
redistribute maximum-prefix 350 70
redistribute bgp 1.65500 route-policy SITE_1_POLICY
interface GigabitEthernet 0/4/0/5
neighbor 10.22.1.1
!
!
!
Document Title
Cisco ASR 9000 Series Aggregation Services Router
Routing Command Reference
Implementing MPLS Layer 3 VPNs module and
Implementing MPLS Layer 2 VPNs module in
Cisco ASR 9000 Series Aggregation Services Router
MPLS Configuration Guide
Implementing MPLS Traffic Engineering on Cisco
ASR 9000 Series Router module in Cisco ASR 9000
Series Aggregation Services Router MPLS
Configuration Guide
Implementing EIGRP