Attaching A Routing Policy To A Bgp Neighbor - Cisco ASR 9000 Series Routing Configuration Manual

Implementing Routing Policy
DETAILED STEPS
Command or Action
Step 1
configure
Step 2 route-policy name [ parameter1 , parameter2 , . . .
, parameterN ]
Example:
RP/0/RSP0/CPU0:router(config)# route-policy
sample1
Step 3
end-policy
Example:
RP/0/RSP0/CPU0:router(config-rpl)# end-policy
Step 4 commit

Attaching a Routing Policy to a BGP Neighbor

This task explains how to attach a routing policy to a BGP neighbor.
Before You Begin
A routing policy must be preconfigured and well defined prior to it being applied at an attach point. If a policy
is not predefined, an error message is generated stating that the policy is not defined.
SUMMARY STEPS
1. configure
2. router bgp as-number
3. neighbor ip-address
4. address-family { ipv4 unicast | ipv4 multicast | ipv4 labeled-unicast | ipv4 tunnel | ipv4 mdt |
ipv6 unicast | ipv6 multicast | ipv6 labeled-unicast | vpnv4 unicast | vpnv6 unicast }
5. route-policy policy-name { in | out }
6. commit
DETAILED STEPS
Command or Action
Step 1
configure
Cisco ASR 9000 Series Aggregation Services Router Routing Configuration Guide, Release 5.3.x
Attaching a Routing Policy to a BGP Neighbor
Purpose
Enters route-policy configuration mode.
• After the route-policy has been entered, a group of
commands can be entered to define the route-policy.
Ends the definition of a route policy and exits route-policy
configuration mode.
Purpose
619