Enable Rcmd Monitoring For Ospf Prefixes - Cisco ASR 9000 Series Routing Configuration Manual

Enable RCMD Monitoring for OSPF Prefixes

SUMMARY STEPS
1. configure
2. router isis instance-id
3. address-family {ipv4 | ipv6} [unicast | multicast]
4. monitor-convergence
5. prefix-list prefix-list-name
6. commit
DETAILED STEPS
Command or Action
Step 1 configure
Step 2 router isis instance-id
Example:
RP/0/RSP0/CPU0:router(config)#router isis isp
Step 3 address-family {ipv4 | ipv6} [unicast | multicast]
Example:
RP/0/RSP0/CPU0:router(config-isis)#address-family ipv6
unicast
Step 4
monitor-convergence
Example:
RP/0/RSP0/CPU0:router(config-isis-af)#monitor-convergence
Step 5 prefix-list prefix-list-name
Example:
RP/0/RSP0/CPU0:router(config-isis-af-rcmd)#prefix-list
isis_monitor
Step 6
commit
Enable RCMD Monitoring for OSPF Prefixes
Perform this task to enable individual prefix monitoring for OSPF prefixes.
Before You Begin
To enable monitoring of individual prefixes, first configure a prefix-list using the {ipv4 | ipv6} prefix-list
command. Then, use this prefix list with the prefix-list command.
Cisco ASR 9000 Series Aggregation Services Router Routing Configuration Guide, Release 5.3.x
652
Implementing RCMD
Purpose
Enables IS-IS routing for the specified routing
instance, and places the router in router
configuration mode.
Enter the IS-IS address-family configuration
mode.
Enables route convergence monitoring for
IS-IS protocol.
Enables individual prefix monitoring for IS-IS
prefixes.