Redistribute Routes Into Ospf - Cisco ASR 9000 Series Routing Configuration Manual

Redistribute Routes into OSPF

Redistribute Routes into OSPF
This task redistributes routes from an IGP (could be a different OSPF process) into OSPF.
Before You Begin
For information about configuring routing policy, see Implementing Routing Policy on Cisco ASR 9000
Series Router module in the Cisco ASR 9000 Series Aggregation Services Router Routing Configuration
Guide.
SUMMARY STEPS
1. configure
2. Do one of the following:
3. router-id { router-id }
4. redistribute protocol [ process-id ] { level-1 | level-1-2 | level-2 } [ metric metric-value ] [
metric-type type-value ] [ match { external [ 1 | 2 ]} [ tag tag-value ] [ route-policy policy-name ]
5. Do one of the following:
6. commit
DETAILED STEPS
Command or Action
Step 1 configure
Step 2 Do one of the following:
• router ospf process-name
• router ospfv3 process-name
Example:
RP/0/RSP0/CPU0:router(config)# router ospf 1
or
RP/0/RSP0/CPU0:router(config)# router ospfv3 1
Step 3 router-id { router-id }
Cisco ASR 9000 Series Aggregation Services Router Routing Configuration Guide, Release 5.3.x
454
• router ospf process-name
• router ospfv3 process-name
• summary-prefix address mask [ not-advertise ] [ tag tag ]
• summary-prefix ipv6-prefix / prefix-length [ not-advertise ] [ tag tag ]
Purpose
Enables OSPF routing for the specified routing process and
places the router in router configuration mode.
or
Enables OSPFv3 routing for the specified routing process and
places the router in router ospfv3 configuration mode.
Note The process-name argument is any alphanumeric string
no longer than 40 characters.
Configures a router ID for the OSPF process.
Implementing OSPF