Implementing and Monitoring RIB
DETAILED STEPS
Command or Action
Step 1
router rib
Example:
RP/0/RSP0/CPU0:router# route rib
Step 2
address-family { ipv4 | ipv6 } next-hop dampening disable
Example:
RP/0/RSP0/CPU0:router(config-rib)# address family ipv4
next-hop dampening disable
Step 3
commit
Configuring RCC and LCC
Enabling RCC and LCC On-demand Scan
Perform this task to trigger route consistency checker (RCC) and Label Consistency Checker (LCC) on-demand
scan. The on-demand scan can be run on a particular address family (AFI), sub address family (SAFI), table
and prefix, vrf, or all prefixes in the table.
SUMMARY STEPS
1. Use one of these commands.
2. Use one of these commands.
• show rcc {ipv4 | ipv6} unicast [all] [prefix/mask] [vrf vrf-name]
• show lcc {ipv4 | ipv6} unicast [all] [prefix/mask] [vrf vrf-name]
• clear rcc {ipv4 | ipv6} unicast [all] [prefix/mask] [vrf vrf-name] log
• clear lcc {ipv4 | ipv6} unicast [all] [prefix/mask] [vrf vrf-name] log
Cisco ASR 9000 Series Aggregation Services Router Routing Configuration Guide, Release 5.3.x
Configuring RCC and LCC
Purpose
Enters RIB configuration mode.
Disables next-hop dampening for IPv4
address families.
509