Cisco ASR 9000 Series Routing Configuration Manual page 240

Information About Implementing BGP Flowspec
0x8006
0x8008
0x8009
Cisco ASR 9000 Series Aggregation Services Router Routing Configuration Guide, Release 5.3.x
210
traffic-rate 0 Drop The traffic-rate extended community is a non-transitive extended
community across the autonomous-system boundary and uses
traffic-rate Police
following extended community encoding:
<rate>
The first two octets carry the 2-octet id, which can be assigned from
a 2-byte AS number. When a 4-byte AS number is locally present,
the 2 least significant bytes of such an AS number can be used. This
value is purely informational. The remaining 4 octets carry the rate
information in IEEE floating point [IEEE.754.1985] format, units
being bytes per second. A traffic-rate of 0 should result on all traffic
for the particular flow to be discarded.
Command syntax
police rate < > | drop
redirect-vrf Redirect The redirect extended community allows the traffic to be redirected
VRF to a VRF routing instance that lists the specified route-target in its
import policy. If several local instances match this criteria, the choice
between them is a local matter (for example, the instance with the
lowest Route Distinguisher value can be elected). This extended
community uses the same encoding as the Route Target extended
community [RFC4360].
Command syntax based on route-target
redirect {ipv4} extcommunity rt <route_target_string>
traffic-marking Set The traffic marking extended community instructs a system to modify
DSCP the differentiated service code point (DSCP) bits of a transiting IP
packet to the corresponding value. This extended community is
encoded as a sequence of 5 zero bytes followed by the DSCP value
encoded in the 6 least significant bits of 6th byte.
Command syntax
set dscp <6 bit value>
set ipv4 traffic-class <8 bit value>
Implementing BGP Flowspec