Configure Link Group Interface - Cisco NCS 6000 Series Configuration Manual

Configure Link Group Interface

point-to-point
address-family ipv4 unicast
link-group foo
RP/0/RSP0/CPU0:Iguazu#sh isis interface gig 0/0/0/1
Thu Jun 11 14:55:32.565 CEST
GigabitEthernet0/0/0/1
Adjacency Formation:
Prefix Advertisement:
IPv4 BFD:
IPv6 BFD:
BFD Min Interval:
BFD Multiplier:
Circuit Type:
Media Type:
Circuit Number:
Extended Circuit Number:
Next P2P IIH in:
LSP Rexmit Queue Size:
Level-2
CLNS I/O
IPv4 Unicast Topology:
IPv4 Address Family:
LSP transmit timer expires in 0 ms
LSP transmission is idle
Can send up to 9 back-to-back LSPs in the next 0 ms
Configure Link Group Interface
Perform this task to configure link group under Intermediate System-to-Intermediate System (IS-IS) interface
and address-family sub-mode:
Routing Configuration Guide for Cisco NCS 6000 Series Routers, IOS XR Release 6.4.x
250
Adjacency Count:
LSP Pacing Interval:
PSNP Entry Queue Size:
Protocol State:
MTU:
SNPA:
Layer-2 MCast Groups Membership:
All ISs:
Adjacency Formation:
Prefix Advertisement:
Metric (L1/L2):
Weight (L1/L2):
MPLS Max Label Stack:
MPLS LDP Sync (L1/L2):
Link-Group (L1/L2):
Metric-Offset (L1/L2):100/100
Protocol State:
Forwarding Address(es): 100.5.6.6
Global Prefix(es):
Enabled
Enabled
Enabled
Disabled
Disabled
150
3
level-2-only (Interface circuit type is level-1-2)
P2P
0
36
8 s
0
1
33 ms
0
Up
1497
0026.9829.af19
Yes
Enabled
Running
Running
110/110
0/0
1
Disabled/Disabled
Configured/Configured
Enabled
Up
100.5.6.0/24
Implementing IS-IS